Issues with Quad Gantry

[k2thestank]

when i first setup my v2.4 it would allow multiple QUAD_GANTRY_LEVEL macro pushes now it only does it once and it seems to be perfect in the middle high in the front and scratches the back

I'm at my wits end as to why this is now occurring, because it was working so great before

Running an Eddy USB as my probe and end stop

 

[amahdi]

This is my first build voron 2.4 350 LDO kit (Rev D). using inductive probe. Fixed the gantry square and re did the frame (had square issue, now fixed). I almost re did everything (as I did issue with the QGL and print problems). Now I run the QGLit runs initially and then I start hiving issue with QGL: Retries aborting: Probed points range is increasing. Possibly Z motor numbering is wrong. I did the rewiring of the otors and check the wiring diagram on LDO wiring guide still the same. When I tried to do the bed mesh it stopes due to exceeding tolerance. Not sure iabout changing the probe to tap instead of the inductive probe?

 

[Aim-iliO]

This is my first build voron 2.4 350 LDO kit (Rev D). using inductive probe. Fixed the gantry square and re did the frame (had square issue, now fixed). I almost re did everything (as I did issue with the QGL and print problems). Now I run the QGLit runs initially and then I start hiving issue with QGL: Retries aborting: Probed points range is increasing. Possibly Z motor numbering is wrong. I did the rewiring of the otors and check the wiring diagram on LDO wiring guide still the same. When I tried to do the bed mesh it stopes due to exceeding tolerance. Not sure iabout changing the probe to tap instead of the inductive probe?

Check if all the screws are tight. I had 2 loose screws in the gantry at he A Motor mount.