- Printer Model
- Voron 2.4 R2 LDO rev. D kit
- Extruder Type
- Clockwork 2
- Cooling Type
- Stealthburner
Hello all, my first post and my first Voron 2.4 / Klipper build so I apologize if I call something by the wrong term.
I am building a Voron 2.4 from an LDO rev D kit with the Nitehawk-SB tool head board and I cannot get either of the fans or the LEDs to work. I am able to get the hotend to heat up, temp sensors are reporting correctly and I have the Klicky probe working perfectly. I have checked that there is power, 24v and 5v, going to the fan board but for the life of me I cannot figure out how to get any of it to turn on. I have followed the LDO instructions and have the printer.cfg, nitehawk-sb.cfg, and tacho_macros.cfg loaded and edited for my machine up to a point. There is still a lot that I need to go through.
Because I am new to Klipper I am sure it is something not being called correctly in the .cfg files but not sure where.
I have attached the .cfg files but not sure what else is needed to help diagnose my issue.
Thanks for any help.
I am building a Voron 2.4 from an LDO rev D kit with the Nitehawk-SB tool head board and I cannot get either of the fans or the LEDs to work. I am able to get the hotend to heat up, temp sensors are reporting correctly and I have the Klicky probe working perfectly. I have checked that there is power, 24v and 5v, going to the fan board but for the life of me I cannot figure out how to get any of it to turn on. I have followed the LDO instructions and have the printer.cfg, nitehawk-sb.cfg, and tacho_macros.cfg loaded and edited for my machine up to a point. There is still a lot that I need to go through.
Because I am new to Klipper I am sure it is something not being called correctly in the .cfg files but not sure where.
I have attached the .cfg files but not sure what else is needed to help diagnose my issue.
Thanks for any help.