Octopus v1.1 can bus 5v power

[zfddude]

I am setting up a octopus v1.1 to use a EBB42 expansion board and the board needs power and ground as well as the signal wires. Where can I plug the power and ground into on the board for can? The board only appear to have 2 can connectors whereas the previous version had a rj11/rj12 connector which would have 4.

 

[NoGuru]

Power can ground has to come from a 24v source. You can run them right from the power supply.
For example here you can see High, Low, VCC or VIN and Ground.

 

[zfddude]

Thanks, for some reason I thought it was getting powered by 5v, I probably shouldn’t use 22awg wire to power it then right?

 

[NoGuru]

Thanks, for some reason I thought it was getting powered by 5v, I probably shouldn’t use 22awg wire to power it then right?

I think 22awg is too small. I think for the toolhead I used 18awg for VCC and ground and 22awg for High, low.