Hi
when I start a print the bed temp goes up OK but then the nozzle goes up to print temp but I want it to go to 150 degrees before probing. Currently goes to 250(ABS) and then waits until it drops to 150 before probing. See part of printer.cfg.
[gcode_macro PRINT_START]
gcode:
# This part fetches data from your slicer. Such as bed temp, extruder temp, chamber temp and size of your printer.
{% set target_bed = params.BED|int %}
{% set target_extruder = params.EXTRUDER|int %}
#{% set target_chamber = params.CHAMBER|default("40")|int %}
{% set x_wait = printer.toolhead.axis_maximum.x|float / 2 %}
{% set y_wait = printer.toolhead.axis_maximum.y|float / 2 %}
# Homes the printer, sets absolute positioning and updates the Stealthburner leds.
STATUS_HOMING # Sets SB-leds to homing-mode
G28 # Full home (XYZ)
G90 # Absolut position
BED_MESH_CLEAR # Clears old saved bed mesh (if any)
G1 X{x_wait} Y{y_wait} Z15 F9000 # Goes to center of the bed
M190 S{target_bed} # Sets the target temp for the bed
# Heating nozzle to 150 degrees. This helps with getting a correct Z-home
M109 S150 # Heats the nozzle to 150c
As far as I can see it should set bed to print temp and then after set extruder to 150, why is something jumping in between these macro lines to set extruder to print temp? I can see no other macro being called between the bed temp set and the extruder 150 set.
Thanks in advance.
when I start a print the bed temp goes up OK but then the nozzle goes up to print temp but I want it to go to 150 degrees before probing. Currently goes to 250(ABS) and then waits until it drops to 150 before probing. See part of printer.cfg.
[gcode_macro PRINT_START]
gcode:
# This part fetches data from your slicer. Such as bed temp, extruder temp, chamber temp and size of your printer.
{% set target_bed = params.BED|int %}
{% set target_extruder = params.EXTRUDER|int %}
#{% set target_chamber = params.CHAMBER|default("40")|int %}
{% set x_wait = printer.toolhead.axis_maximum.x|float / 2 %}
{% set y_wait = printer.toolhead.axis_maximum.y|float / 2 %}
# Homes the printer, sets absolute positioning and updates the Stealthburner leds.
STATUS_HOMING # Sets SB-leds to homing-mode
G28 # Full home (XYZ)
G90 # Absolut position
BED_MESH_CLEAR # Clears old saved bed mesh (if any)
G1 X{x_wait} Y{y_wait} Z15 F9000 # Goes to center of the bed
M190 S{target_bed} # Sets the target temp for the bed
# Heating nozzle to 150 degrees. This helps with getting a correct Z-home
M109 S150 # Heats the nozzle to 150c
As far as I can see it should set bed to print temp and then after set extruder to 150, why is something jumping in between these macro lines to set extruder to print temp? I can see no other macro being called between the bed temp set and the extruder 150 set.
Thanks in advance.