What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

To Tap or Not to Tap

kgearhardt

New member
So after a couple of years of procrastination with all of my Voron 2.x parts in the basement, I’m finally starting my build for my 2.4r2. I had some indeterminate revision ABS parts on hand, so I decided to reprint everything.

So to my question, starting from scratch at this point should I go with Stealthburner with tap right out of the gate? Or should I save that as an upgrade after I get the printer up and running without?

Thanks!
 
Thanks folks, TAP it will be then. I'm not worried about the build aspect, and I believe most of my "learning" on this Voron path will be Klipper since I've never used it.

Cheers!
 
You're in for a treat then, Klipper is 100 million times better then Marlin. Being able to edit the config and hit save is the game changer vs re compiling the entire config.
I think because of this, it makes the code easier to learn as well.
 
Top