Yet another probe question for new 2.4 build

[Coyote]

I'm building a 2.4 with Stealthburner, self sourced parts all except probe. At first I was planning on Klicky (PCB) but recently read up on Tap so now I'm dithering with indecisiveness. My inclination is to get off the pot and just go with Klicky and upgrade to Tap later. But since I haven't got to the Stealthburer install yet...you see where this is going so any input/suggestions? Maybe y'all's wind can blow me off this fence I'm stuck on...

 

[NoGuru]

Both are great probes. Klicky is light, fun to watch and very reppetible. Tap is more accurate, much easier to setup and install, but heavy.
If you are not chasing every last bit of speed I would go TAP.