Current visitors

Everyone Members Guests Robots

1. Guest

   • Viewing latest content
   • 5 minutes ago
2. Guest

   • Viewing thread Printer is not ready The klippy host software is attempting to connect.
   • 5 minutes ago
3. Guest

   • Viewing member profile PoiTEE
   • 5 minutes ago
4. Guest

   • Viewing forum list
   • 5 minutes ago
5. Guest

   • Viewing member profile FreedomFractions
   • 5 minutes ago
6. Guest

   • Viewing thread Happy Valentine's from VORON Design
   • 5 minutes ago
7. Guest

   • Viewing member profile Boot
   • 5 minutes ago
8. Guest

   • Viewing thread Periodic under-extrusion issue on 300mm Voron 2.4 R2
   • 5 minutes ago
9. Guest

   • Viewing member profile voron user
   • 6 minutes ago
10. Guest

    • Viewing thread Rapido Current Draw & Octopus
    • 6 minutes ago
11. Guest

    • Viewing thread Very different results between SuperSlicer 2.5 vs 2.4?
    • 6 minutes ago
12. Guest

    • Viewing thread Really just curious more than anything, what nozzle sizes to folks like to use on their 2.4's?
    • 6 minutes ago
13. Guest

    • Viewing thread TAP as Z end stop
    • 6 minutes ago
14. Guest

    • Viewing member profile incogizmo
    • 6 minutes ago
15. Guest

    • Viewing member profile claudermilk
    • 6 minutes ago
16. Guest

    • Viewing member profile phrac
    • 6 minutes ago
17. Guest

    • Viewing thread Where can I buy a high quality voron 2.4 kit?
    • 6 minutes ago
18. Guest

    • Viewing thread Places to look when troubleshooting skew
    • 6 minutes ago
19. Guest

    • Viewing member profile bk77574
    • 7 minutes ago
20. Guest

    • Viewing thread Help needed with "Extrude below minimum temp" on first print with Tap.
    • 7 minutes ago