1.8 socketed vs 0.9 wired steppers? LDO kit

[thespacecowboy]

Printer Model

Voron 2.4

Hello. I have the LDO Voron 2.4 kit here from MH. The kit came with 4x 1.8 NEMA17 and 2x 0.9 NEMA17.

I am uncertain, hence the thread, but assume that the 1.8's go on the bottom of the printer, and the 0.9's on the gantry?

Can anyone please confirm? Thank you so much

 

[thespacecowboy]

Guess this forum has no mods

 

[Sanity Agathion]

Guess this forum has no mods

Apologies, mods are busy with ongoing real-life event. We are only volunteers with so much spare time.

Yes, 0.9 go as AB motors and 1.8 are Z motors. Of course you can mix and match however you like but this seems most logical solution.
If you are not sure, contact seller or manufacturer for confurmation.

 

[thespacecowboy]

Apologies, mods are busy with ongoing real-life event. We are only volunteers with so much spare time.

Yes, 0.9 go as AB motors and 1.8 are Z motors. Of course you can mix and match however you like but this seems most logical solution.
If you are not sure, contact seller or manufacturer for confurmation.

Thanks for the thread approval and the answer.