What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

50MHZ showed for Raspberry PI 4 in Mainsail

informel

Member
When I look inside Mainsail, I see this:

mcu rpi(linux)
Version: v0.11.0-279-g7bd32994
Load: 0.02, Awake: 0.00, Freq: 50 MHz,

Is this normal ?
Anything wrong with my PI ?
 
I can't verify since I'm not at home, but I would imagine the low frequency is due to the Pi not doing anything requiring higher clock speeds. No need to have high clock speeds and power consumption if it's just sitting idle.
 
Looking at my Trident on a Pi3 and V0 on a Pi3, both show the same 50mhz. I assume that's normal and it's fine for running the printers.
 
Looking at my Trident on a Pi3 and V0 on a Pi3, both show the same 50mhz. I assume that's normal and it's fine for running the printers.
I found out that this is normal
You are probably setup to do the resonance test and the PI as to be setup in a way to expose some GPIO pins and it shows as an additional MCU with limited capacity in order to keep the PI responsive
 
Top