klicky probe attach (no problem) wont dock properly

[Ho-whizzle]

Printer Model

Voron Micron pLus

Extruder Type

Clockwork 2

Cooling Type

Other

Hello again.

I dont know what happened but all of sudden the klicky probe docks back into the holder about 1.5 - 2mm shorter than the original attaching position causing the probe to drop off 100% of the time when docking back the probe after homing Z.

I have tried varies Y postion for the dock location and the same happens, attaches the probe fine but docking back it falls short and drops off.

I am really confused why this happening. hope you can help.

 

[lord-carlos]

I had that a few times when a cable was between the gantry and the back while homing. It would result in inconstant Y homing.