Hi. I'm upgrading my V24 with LDO's nighthawk toolboard. I'm using a Galileo 2 extruder with stealthburner. I downloaded the cable chain anchor from LDOs nitehawk website. I'm at a complete loss on how and where to mount the anchor on the Galileo 2. Is there a mod to the Galileo to accommodate this anchor? What am I missing? Any help would be appreciated. I posted this on Discord as well. Thanks.
VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
LDO Nitehawk toolboard with Galileo 2 extruder.
- Thread starter FriedPCB
- Start date
Is there chain mount for the G2 that is specifically designed for the nitehawk toolboard? The standard chain mount for the G2 in my opinion is too high relative to where the cable exits the tool board. Using the standard G2 chain mount would force too sharp a bend on the harness wire.
Hello, sorry to for commenting old thread but i also have similar problem. Is there a STL file somewhere, what you could print and use to secure the usb-cable to the toolhead for Nitehawk-SB and Galileo 2 for Stealthburner ?
Attachments
Hi. I never found one. I ended up using the standard chain mount. It's a tight bend but it works. I have had no issues.
I found this one from printables. I will try fo fit it for this setop:
www.printables.com
I ripped my can-bus connector off from previous board (by mistake). This time I try to be more safe and secure the cable better and not to do same mistake two times....
Galileo 2 + LDO Nitehawk SB USB cable strain relief / cable gland by Iconic FAB | Download free STL model | Printables.com
No PG-7 cable gland required. | Download free 3D printable STL models
www.printables.com
I ripped my can-bus connector off from previous board (by mistake). This time I try to be more safe and secure the cable better and not to do same mistake two times....
