What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Solved Looking for proper STLs for LRS-350-24 power supply DIN rail mounts

wowmonkey

New member
I'm likely missing something obvious, but I can't seem to find the STLs for the brackets to mount a Mean Well LRS-350-24 power supply. Any help pointing me in the right direction would be appreciated!
Thanks!
 
Last edited:
Thanks, but that was the first place I looked. I can't seem to figure out how it should attach to the PSU? Manual shows screw holes through the entire bracket. PSU has m3 female mounts spaced 50mm apart. How do I get a screw through that piece? See attached images.
 

Attachments

  • u350.png
    u350.png
    25.9 KB · Views: 8
  • manual.png
    manual.png
    29.3 KB · Views: 7
I wish I had the STEP files for those. The single mount on the 5v PSU allows it to flop around like a wet noodle. Ok, maybe not that bad but I would like to make it wider for better support. I supposed I could just draw it up in SW.
 
Top