- Printer Model
- Voron 2.4
- Extruder Type
- Clockwork 1
- Cooling Type
- Stealthburner
My equipment:
Voron 2.4 board Manta-M8P v2 + CB1, head Stealthburner with EBB 2240, Eddy Coil , Knomi v2
Eddy coil is connected to the i2c port on the MP8 v2 board
Knomi v2 is connected as usual via wi-fi
Eddy coil is configured, works fine, scans and levels the table!
But very often an error appears!!! ~MCU 'mcu' shutdown: i2c timeout~, Sometimes an error appears MCU shutdown: i2c timeout
I think this error is related to Eddie because he is the only one connected to the i2c bus!
I noticed that when Eddie is turned on, Knomi loses Wifi
~~here is my configuration~~~
[probe_eddy_current btt_eddy]
sensor_type: ldc1612
z_offset: 1
i2c_mcu: mcu
i2c_bus: i2c3_PA8_PC9
x_offset:0
y_offset: 20
data_rate: 500
Gentlemen, do you have any thoughts???
Voron 2.4 board Manta-M8P v2 + CB1, head Stealthburner with EBB 2240, Eddy Coil , Knomi v2
Eddy coil is connected to the i2c port on the MP8 v2 board
Knomi v2 is connected as usual via wi-fi
Eddy coil is configured, works fine, scans and levels the table!
But very often an error appears!!! ~MCU 'mcu' shutdown: i2c timeout~, Sometimes an error appears MCU shutdown: i2c timeout
I think this error is related to Eddie because he is the only one connected to the i2c bus!
I noticed that when Eddie is turned on, Knomi loses Wifi
~~here is my configuration~~~
[probe_eddy_current btt_eddy]
sensor_type: ldc1612
z_offset: 1
i2c_mcu: mcu
i2c_bus: i2c3_PA8_PC9
x_offset:0
y_offset: 20
data_rate: 500
Gentlemen, do you have any thoughts???