- Printer Model
- Voron Trident
Feasibility question: would it be reasonable to build a Trident using a BTT SKR V1.4 (non-turbo), remapping the klipper/config/generic-bigtreetech-skr-v1.4.cfg to drive the A, B and 3 Z steppers, and use a CANbus toolhead board with a USB-to-CANbus adapter on the RPi? I'm trying to reuse some parts from my stash, namely:
a) Raspberry Pi 3B host
b) BTT SKR V1.4 (LPC 1768) primary MCU
c) 5X TMC2130 stepper drivers
d) Meanwell SE-450-24 (24V, 18.8A) 450W power supply
Other than less than leading-edge performance, what would be the downside in this configuration?
Best regards,
Willie
a) Raspberry Pi 3B host
b) BTT SKR V1.4 (LPC 1768) primary MCU
c) 5X TMC2130 stepper drivers
d) Meanwell SE-450-24 (24V, 18.8A) 450W power supply
Other than less than leading-edge performance, what would be the downside in this configuration?
Best regards,
Willie
