Unable to read tmc uart 'stepper_x' register IF NT

[caden0324]

I have this error on fluidd for my voron 0.2 kit, could anyone please help?

Board: Fly gemini v3
Tmc: fly tmc 2209

Below is my attached file for my printer.cfg

I did not include the board because when I uncommand it the error showed that this file is not found.

 

[bomtarnes]

If you are building a siboor v0.2 kit this should all have been pre-configured for you.

You do need the FLY_GEMINI_V3.cfg file, without it klipper will be unable to work out which pins go to what. I have attached a copy of it in a zip file.

That file should live in: /printer_data/config/boards/

 

[caden0324]

If you are building a siboor v0.2 kit this should all have been pre-configured for you.

You do need the FLY_GEMINI_V3.cfg file, without it klipper will be unable to work out which pins go to what. I have attached a copy of it in a zip file.

That file should live in: /printer_data/config/boards/

May I know is this file located in the image tool originally ? Why I couldn’t find this file is it because I used the wrong image tool?