Guys please help. I have run a probe accuracy python script after installing TAP. and looks like I have a big issue with two corners? The one on 275, 275 is higher than others even though the cript did run QGL. The corner at 25,25 is biggest mistery. I have tried retightening all loop belts, retightened Z belts, retightened all grub screws, retightened gantry bolts (I use IGUS spherical bearing), made sure the belt clamps are tight. I did have some issues with auto Z etc before TAP as well but thought it might have been my old probe. Any other things I can check? Will it be fine if I will run it like this? Steppers are at 32 microsteps and 0.8A. I have also run the 100 samples of Probe accuracy like 5 times for it to set.