What have I done wrong

[Stucarius]

Do you have any idea as to what is wrong? I am currently inclined to completly rebuild the printer.cfg file.

 

[shiftingtech]

Do you have any idea as to what is wrong? I am currently inclined to completly rebuild the printer.cfg file.

I really want to see a screenshot of the console where you're running the command, and getting nothing in response, because that's just...not how it works.

 

[Stucarius]

I wrote an earlier reply but apparently the forum software did not post the reply.

Do you have any thoughts on what might be wrong?

I am inclined to remake the printer.cfg file and see if that helps.

 

[Stucarius]

nor does the machine I took that screenshot on.

OK I ran another query and I got this:
x:TRIGGERED y:TRIGGERED zpen

 

[shiftingtech]

Alright. So. The expected result there is Open for both, until you actually try to home.

So we need to figure out why that's not happening and...I'm embarrassed to admit, I seem to have missed the obvious in your log, days ago.

[stepper_x]
endstop_pin = PC15

and no diag pin setup at all

endstop_pin should be pointing at the virtual endstop, and the diag pin, well, should be configured.

see https://docs.vorondesign.com/tuning/sensorless.html

 

[Upperbottom]

Stucarius, have you set up sensorless homing (shiftingtech links to the instruction for this)?

Only then you get X/Y without endstops (the stepperdrivers become your endstop..sorta).

The eddy probe only senses in z-direction and cannot detect the X/Y dimensions....