- Printer Model
- Voron 2.4
- Extruder Type
- Clockwork 2
Group,
hopefully you can help me because I'm lost. The Z offsets sent to the motors are not correct (see below) when running a QGL.
9:08 PM
Making the following Z adjustments:
stepper_z = 6.572249
stepper_z1 = -5.637549
stepper_z2 = -6.653091
stepper_z3 = 5.718391
9:08 PM
Average: 10.051036
9:08 PM
Actuator Positions:
z: 3.478787 z1: 15.688585 z2: 16.704127 z3: 4.332645
9:08 PM
Gantry-relative probe points:
0: 13.265000 1: 5.712500 2: 6.242500 3: 13.855000
As you can see steppers z1 and z2 move negatively correctly, but z0 and z3 move in a positive direction. And to top it off z0 is double the offset any ideas? attached is my config file
. I'm running an MP8 with Steathburner and CAN bus.
thanks, any input would be welcome.
Mark
hopefully you can help me because I'm lost. The Z offsets sent to the motors are not correct (see below) when running a QGL.
9:08 PM
Making the following Z adjustments:
stepper_z = 6.572249
stepper_z1 = -5.637549
stepper_z2 = -6.653091
stepper_z3 = 5.718391
9:08 PM
Average: 10.051036
9:08 PM
Actuator Positions:
z: 3.478787 z1: 15.688585 z2: 16.704127 z3: 4.332645
9:08 PM
Gantry-relative probe points:
0: 13.265000 1: 5.712500 2: 6.242500 3: 13.855000
As you can see steppers z1 and z2 move negatively correctly, but z0 and z3 move in a positive direction. And to top it off z0 is double the offset any ideas? attached is my config file
. I'm running an MP8 with Steathburner and CAN bus.
thanks, any input would be welcome.
Mark