It was pretty hard to get it right up to it and take the pic. You can see there is a small gap and I did not measure it but I would say its about .15mm just for a short distance maybe .2mm
Settings were
Layer height .2
First layer .2
Line width .42
Inner wall .45
Outer wall .42
Arachne wall
Top layers 3
Bottom layers 3
Wall loops 3
Infill Grid 15%
Speed 105mm/s
Nozzle 260c
Bed 90c
No fan for first 3 layers
Fan speed 80%
Yeah, I have been doing speed boat race testing and the Voron is tied up doing that. This was printed on a Bambu labs X1C.