Darth Avocado
New member
I can't tell if this is Elephant foot or not. I dont think its z-banding or other z axis artifacts because I printed a test cube that came out much better. But, for some odd reason this print seems to have a noticeable bulge at the base.
The model.
Every layer on the bottom is solid infill for weight, and I have 3 walls. Im using Inland Tough-PLA at 215c nozzle temp, 70C on the bed, and my machine is a Voron 2.4 350mm variant. I also did a benchy test print and the bottom text came out good, so I think my nozzle offset is accurate. Im not sure what could be going on...maybe some sort of thermal contraction?
The model.
Every layer on the bottom is solid infill for weight, and I have 3 walls. Im using Inland Tough-PLA at 215c nozzle temp, 70C on the bed, and my machine is a Voron 2.4 350mm variant. I also did a benchy test print and the bottom text came out good, so I think my nozzle offset is accurate. Im not sure what could be going on...maybe some sort of thermal contraction?
