new FYSETC 0.2 Pro R1 issues

[tx_wombat]

Printer Model

FYSETC 0.2 Pro R1

Extruder Type

Other

Cooling Type

Stealthburner

New FYSETC 0.2 Pro R1 which uses the Catalyst board pre-loaded etc..
1. On boot I'm getting a error- No trigger on x after full movement and its pushing the X-Asix into the rear right side constantly - TRying to home but sensorless is not working (should be active by default).
Y and Z appears to be fine.

2. The bed heater / nozzle heater do not appear to be heating up and error out when I manually set the temps in klipper web interface. - the sensor type / heater type should bet set by default - the Github on FYSETC doesnt mention needing to make changes.

thanks for the help.

 

[transonic_gecko]

I'm not familiar with the catalyst board. Do you need to add any jumpers to enable sensors homing?

 

[tx_wombat]

Nothing based on the github - https://github.com/FYSETC/FYSETC-Voron-0.2-Pro/tree/main/0.2 R1
Also Y Axis is sensor less and its only on the X that it fails (but it does move at boot) - I assume 0,0 (X,Y) is at back right.... or is this reversed somehow?

Z is on a Z-stop and is fine.

 

[Sandman50]

0,0,0 should be front left.

So:

[stepper_x]
position_endstop: 120
position_min: -1.5
position_max: 120

 

[tx_wombat]

Thanks - I'll boot it up today and check those settings.

 

[tx_wombat]

Working alot better - but still a little stuck.... getting a Klipper shutdown but i'll post a new topic to cover.