Rapido UHF mod for Stealthburner

[bythorsthunder]

A mod that extends the stealthburner cowling and front toolhead mount to accommodate the longer Rapido UHF configuration. Results in a loss of z travel of about 6mm.

Adding Rapido UHF Stealthburner support. by bythorsthunder · Pull Request #820 · VoronDesign/VoronUsers

[x ] The mod, firmware configuration or slicer profile is in the correct category folder. Printable mods go to printer_mods/, firmware configurations go to firmware_configurations/, slicer profiles...

github.com

 

[Trippinonaduck]

What is the probing solution with all the added distance from the carraige?

 

[bythorsthunder]

What is the probing solution with all the added distance from the carraige?

Good question. Some people using the mod with the inductive probe have had a far enough sense distance that with the probe at the lowest position it's still working ok. Most people using it are doing so with klicky which seems to work fine by dropping the mount in the slots a tiny bit. It may also require the use of the variable dock mount from the klicky repo.

 

[JosAr]

there are some klicky probes that are longer and useful for this, like an unklicky.

 

[bythorsthunder]

there are some klicky probes that are longer and useful for this, like an unklicky.

Great point. I'll be sure to recommend that when this comes up next.

 

[EricZimmerman]

can confirm this one works great, but i needed to use the omron adapter for euclid to be able to adjust things back to the dock.

 

[Turge]

I'm using this mod with Tap and it's working great.