- Printer Model
- Voron 0.2
Hi,
I'm an Engineering student from NYC. Last year I took on a Voron 0.2 project as I had a plethora of time to tinker and learn. Since then, I transferred to a much more rigorous University. Consequently, I haven't had any time to work on my Voron 0.2.
The build is almost entirely complete. I have assembled and wired everything. However, I noticed it isn't properly square so it will need to be squared up. As far as the software side goes. I got started with getting Klipper on the board. I set up sensorless homing and such as well. An experienced builder would probably finish this project in a weekend if not less.
I will pay someone to complete this build for me, as I still love the printer and have already invested over 40 hours into it. Please send me an email regarding this at jisunz994@gmail.com
I'm an Engineering student from NYC. Last year I took on a Voron 0.2 project as I had a plethora of time to tinker and learn. Since then, I transferred to a much more rigorous University. Consequently, I haven't had any time to work on my Voron 0.2.
The build is almost entirely complete. I have assembled and wired everything. However, I noticed it isn't properly square so it will need to be squared up. As far as the software side goes. I got started with getting Klipper on the board. I set up sensorless homing and such as well. An experienced builder would probably finish this project in a weekend if not less.
I will pay someone to complete this build for me, as I still love the printer and have already invested over 40 hours into it. Please send me an email regarding this at jisunz994@gmail.com
