Solved bad interference between stealthburner_printhead_dragon_rear_cw2 and BHCSs on TAP

[EvilleRock]

Is there a TAP compatible version of stealthburner_printhead_dragon_rear_cw2.stl or am I doing something else wrong? TIA

edit: Oh never mind. I only had to loosen some guide screws and it slid right in place. It doesn't take much to stump me, I'm sorry to say.

 

[Oberon]

Thanks for updating your post with the solution. I did have the same issue when upgrading, it's not a design flaw it's just that it's stiffer and more constrained than the SB or even AB mounting which I was used to.